The Smart DEM is one of several Electric Discharge Machines that Knuth Machine Tools USA offers. The Knuth Smart DEM is designed to be a simple, low cost wire EDM machine that can produce the lowest part cost, the company said. Along with simplicity and low cost, the Knuth Smart DEM can hold a workpiece of 13.8” x 17.7” x 7. 9” and has full 4-axis capability for draft angles up to +/- 5-degrees (4” workpiece). These machines have a power supply that is good for cutting certain materials, like graphite, that do not cut well on other machines, the company said. This machine uses ELAPT 3.2 software that runs off-line, and programs can be downloaded to the machine with the USB port that Knuth adds to machines in the United States. The Knuth Smart DEM can be programmed down to 0.000004” increments and achieves positioning accuracies of 0.0008”. Flushing is used instead of full submersion and achieves very fine cuts with surface finishes down to 1.2 ìm Ra. The Knuth Smart DEM comes with the programming software, diamond guides, paper filter and more. For more information contact: KNUTH Machine Tools USA 590 Bond St. Lincolnshire, IL 60069 847-415-3333 info@knuth-usa.com www.knuth-usa.com